Page 1 of 1
Dreamcast with 4 security torx screw heads
Posted: Tue Apr 05, 2011 10:23 pm
by Tmmy92
While some Dreamcast consoles have 4 Phillips screws on the bottom, my dreamcast has 4 6-pointed star torx screws(which have the same size as the Phillips screws have for the dreamcast). so what kind of screwdriver should I use?
Re: Dreamcast with 4 security torx screw heads
Posted: Tue Apr 05, 2011 11:16 pm
by cOcOoO
If the screws are TORX, you should use TORX. You don't eat soup with a fork, you use a spoon.
Re: Dreamcast with 4 security torx screw heads
Posted: Tue Apr 05, 2011 11:24 pm
by Tmmy92
I know but what i meant to say is, what kind of torx screwdriver should i use(for example:T1,T10,T5,T8,etc...)
Re: Dreamcast with 4 security torx screw heads
Posted: Wed Apr 06, 2011 12:50 pm
by cOcOoO
if you post pictures, maybe we could help....
Re: Dreamcast with 4 security torx screw heads
Posted: Thu Apr 07, 2011 3:22 pm
by comradesnarky
Can't you just buy a set of torx screw heads? If you do a lot of stuff with electronics, you're going to run into them more often than you want to.
Also, if they are the security heads, you can break the pin in the middle and use a standard torx head. I did it to get into my 360 controllers, I can't remember what i used to do it though. It wasn't hard.