Hi everyone, I ask you a big favor. I am desperately trying to install a sata hard drive with an adapter. I followed the dragon city guide, connected all the points. Nothing to do connected 10 different hard drives both ide and sata, but it remains either blocked or does not start. I have been attentive to the formatting with mbr in fat32 with aomei, but also with gui format and the windows tool, but nothing recognizes the partition in fat32 but it gets stuck with any disk.
Following a user on youtube I also tried to solder pin 1 to a 10k resistor, but nothing, I also tried a 470picofarad ceramic capacitor but nothing the same. On the ide sata adapter I was careful to use the jumper on slave. still nothing.
the only partition that reads me is that of the sd that I installed on serial.