Vespa wrote: ↑Thu May 09, 2024 2:59 pm
No markings on the stick so just noted the DC arcade stick layout in the log
GC2USB (VID 057E PID 0337) hot key START+Z, don't have Twin Stick mode, controller have big dead zone for triggers
Astrocity (VID 0CA3 PID 0028)
usb4maple(GC2USB, Astocity).7z
Thanks, Sega Astrocity stick is perfect.
GC2USB:
Looks like I messed up the notation on this!
-Up and down on the analog stick is currently inverted (up is down etc)
-Map GC 'B' to DC 'X'
-Map GC 'X' to DC 'B'
-I assume vibration can not be supported without the correct byte info?
Start+Z is the twin stick mode? that's cool, can't have everything! Is it possible to map something to the C-Stick, perhaps mirror the D-pad or the main analog stick? Thank you for your hard work.
Vespa wrote: ↑Fri May 10, 2024 4:41 am
Start+Z is the twin stick mode? that's cool, can't have everything! Is it possible to map something to the C-Stick, perhaps mirror the D-pad or the main analog stick? Thank you for your hard work.
fixed, added vibration test
hold Start+Z and click A or B or X. supported three modes: standart, all axes and FPS
MoeFoh wrote: ↑Fri May 10, 2024 8:09 am
MAYFLASH F101 ARCADE STICK - D-INPUT
megavolt85 wrote: ↑Fri May 10, 2024 9:09 am
fixed, added vibration test
hold Start+Z and click A or B or X. supported three modes: standart, all axes and FPS
usb4maple(fix GC2USB, MyFlash F101).7z
-GC mapping FIXED. Thank you, the hotkey modes are excellent additions!
-The option to enable vibration is now available in game menus with this firmware, however it will not vibrate. If you plug in the second grey USB on the Mayflash adapter (for power) the controls will stop responding. The Dreamcast still reports/sees the pad as detected/active when this happens (no controller disconnected messages)
Good evening, I was moving towards a vga cable, but my tv has no vga input. The only way is a VGAtoHDMI adapter. I wanted to know if the resolution...
Last post
Thanks for the replies, my intention was to take advantage of the native vga signal, also because I didn't want a thousand boxes to look after.
I'll...